2V0-41.20 Updated Exam Dumps [2023] Practice Valid Exam Dumps Question
2V0-41.20 Sample with Accurate & Updated Questions
NEW QUESTION # 35
Which network virtualization technologies can be used with an Ethernet VPN (EVPN) deployment in NSX-T Data Center? (Choose two.)
- A. Virtual Routing and Forwarding (VRF)
- B. Open Shortest Path First (OSPF)
- C. Multiprotocol Border Gateway Protocol (MP-BGP)
- D. Virtual Extensible Local Area Network (VXLAN)
- E. Multiprotocol Label Switching (MPLS)
Answer: C,D
NEW QUESTION # 36
Which two ports are used by a transport node to communicate with the management and control planes in NSX-T Data Center 3.0? (Choose two.)
- A. 0
- B. 1
- C. 2
- D. 3
- E. 4
Answer: A,B
Explanation:
Explanation
The NSX Manager management plane communicates with the transport nodes by using APH Server over NSX-RPC/TCP through port 1234. CCP communicates with the transport nodes by using APH Server over NSX-RPC/TCP through port 1235. Taken from NSX-T ICM 3.0 Lecture manual
NEW QUESTION # 37
An NSX administrator is using ping to check connectivity between VM1 running on ESXi1 to VM2 running on ESXi2. The ping tests fails. The administrator knows the maximum transmission unit size on the physical switch is 1600.
Which command does the administrator use to check the VMware kernel ports for tunnel end point communication?
- A. esxcli network diag ping -I vmk0 -H <destination IP address>
- B. vmkping ++netstack=geneve -d -s 1572 <destination IP address>
- C. vmkping ++netstack=vxlan-d -s 1572 <destination IP address>
- D. esxcli network diag ping -H <destination IP address>
Answer: C
Explanation:
https://kb.vmware.com/s/article/1003728
NEW QUESTION # 38
When deploying east-west network introspection, which Service Virtual Machine (SVM) deployment method achieves the least amount of traffic hairpinning?
- A. Create a secondary vNIC on each quest VM for SVM communication.
- B. Place a partner SVM on each compute cluster node.
- C. Add partner SVMs to an edge cluster.
- D. Centralize partner SVMs in a service cluster.
Answer: A
NEW QUESTION # 39
An NSX administrator would like to export syslog events that capture messages related to NSX host preparation events.
Which message ID (msgid) should be used in the syslog export configuration command as a filter?
- A. MONITORING
- B. GROUPING
- C. FABRIC
- D. SYSTEM
Answer: C
Explanation:
https://docs.vmware.com/en/VMware-NSX-T-Data-Center/3.0/nsxt_30_admin.pdf
NEW QUESTION # 40
Which statement is true about an alarm in a Suppressed state?
- A. An alarm can be suppressed for a specific duration in hours.
- B. An alarm can be suppressed for a specific duration in seconds.
- C. An alarm can be suppressed for a specific duration in days.
- D. An alarm can be suppressed for a specific duration in minutes.
Answer: C
NEW QUESTION # 41
Which network virtualization technologies can be used with an Ethernet VPN (EVPN) deployment in NSX-T Data Center? (Choose two.)
- A. Virtual Routing and Forwarding (VRF)
- B. Open Shortest Path First (OSPF)
- C. Virtual Extensible Local Area Network (VXLAN)
- D. Multiprotocol Border Gateway Protocol (MP-BGP)
- E. Multiprotocol Label Switching (MPLS)
Answer: A,C
NEW QUESTION # 42
Which Network and Security virtualization solution provides network hybridity and mobility?
- A. VMware HCX
- B. NSX Advanced Load Balancer
- C. VMware Tanzu Service Mesh
- D. NSX Intelligence
Answer: A
NEW QUESTION # 43
Which three different transport nodes could be configured in the data plane? (Choose three.)
- A. vShield Edge VM
- B. ESXi and Hyper-V
- C. VM or Bare Metal NSX Edge
- D. ESXi and KVM
- E. NSX Edge VM on KVM
- F. Bare Metal server
Answer: C,D,F
NEW QUESTION # 44
What are two supported N-VDS modes? (Choose two.)
- A. Standard Datapath
- B. Enhanced Datapath
- C. Secure Datapath
- D. DPDK Datapath
- E. Overlay Datapath
Answer: A,B
Explanation:
Explanation
https://docs.vmware.com/en/VMware-NSX-T-Data-Center/3.0/installation/GUID-37BC3CEF-DCC1-4C6F-960D
NEW QUESTION # 45
Which three protocols could an NSX administrator use to transfer log messages to a remote log server? (Choose three.)
- A. SSH
- B. SSL
- C. UDP
- D. TCP
- E. TLS
- F. HTTPS
Answer: C,D,E
NEW QUESTION # 46
An NSX administrator is troubleshooting a connectivity issue with virtual machines running on an ESXi transport node. Which feature in the NSX UI shows the mapping between the virtual NIC and the host's physical adapter?
- A. Port Mirroring
- B. Activity Monitoring
- C. IPFIX
- D. Switch Visualization
Answer: D
NEW QUESTION # 47
What are two supported N-VDS modes? (Choose two.)
- A. Standard Datapath
- B. Enhanced Datapath
- C. Secure Datapath
- D. DPDK Datapath
- E. Overlay Datapath
Answer: A,B
Explanation:
Reference:
https://docs.vmware.com/en/VMware-NSX-T-Data-Center/3.0/installation/GUID-37BC3CEF-DCC1-4C6F-960D-CFBB31908D1C.html
NEW QUESTION # 48
An NSX administrator is planning to deploy a multi-tier routing topology in their NSX-T Data Center environment to provide north-south connectivity for the VMs.
Which routing component must be deployed?
- A. Layer 2 Gateway
- B. Tier-0 Gateway
- C. Edge Services Gateway
- D. Tier-1 Gateway
Answer: B
NEW QUESTION # 49
What are two supported N-VDS modes? (Choose two.)
- A. Standard Datapath
- B. Enhanced Datapath
- C. Secure Datapath
- D. DPDK Datapath
- E. Overlay Datapath
Answer: A,B
Explanation:
https://docs.vmware.com/en/VMware-NSX-T-Data-Center/3.0/installation/GUID-37BC3CEF-DCC1-4C6F-960D-CFBB31908D1C.html
NEW QUESTION # 50
Which step must be performed before deploying an additional NSX Manager from the NSX-T UI?
- A. Configure the Virtual IP of the cluster.
- B. Create an Edge Cluster.
- C. Register vCenter Server as a Compute Manager.
- D. Prepare the ESXi hosts as Transport Nodes.
Answer: C
NEW QUESTION # 51
When running nsxcli on an ESXi host, which command will show the Replication mode?
- A. get logical-switch <Local-Switch-UUID> status
- B. get logical-switches
- C. get logical-switch status
- D. get logical-switch <Logical-Switch-UUID>
Answer: D
Explanation:
Explanation
https://vdc-download.vmware.com/vmwb-repository/dcr-public/cc42e3c1-eb34-4567-a916-147e79798957/82646
NEW QUESTION # 52
An NSX administrator would like to export syslog events that capture messages related to NSX host preparation events.
Which message ID (msgid) should be used in the syslog export configuration command as a filter?
- A. MONITORING
- B. GROUPING
- C. FABRIC
- D. SYSTEM
Answer: C
Explanation:
Explanation
https://docs.vmware.com/en/VMware-NSX-T-Data-Center/3.0/nsxt_30_admin.pdf
NEW QUESTION # 53
Which two statements describe the characteristics of an Edge Cluster in NSX-T 3.0 Data Center? (Choose two.)
- A. can have a maximum of 8 edge nodes
- B. can have a maximum of 10 edge nodes
- C. can contain multiple types of edge nodes (VM or bare metal)
- D. must contain only one type of edge nodes (VM or bare metal)
- E. must have only active-active edge nodes
Answer: B,C
NEW QUESTION # 54
How many IPs are required when deploying a highly available NSX Management Cluster with VIP in a production environment?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: A
NEW QUESTION # 55
Which CLI command on NSX Manager and NSX Edge is used to change NTP settings?
- A. get timezone
- B. set timezone
- C. set ntp-server
- D. set time-server
Answer: C
NEW QUESTION # 56
Which two tools are used to configure centralized logging in NSX-T Data Center? (Choose two.)
- A. vRealize Operations
- B. vRealize Automation
- C. Syslog Server
- D. vRealize Network Insight
- E. vRealize Log Insight
Answer: C,E
NEW QUESTION # 57
Which two choices are prerequisites to configure NSX-T on VDS? (Choose two.)
- A. vSphere Distributed Switch 7.0
- B. MTU 1400
- C. MTU 1500
- D. MTU 1600
- E. vSphere Distributed Switch 6.5
Answer: A,D
Explanation:
https://docs.vmware.com/en/VMware-NSX-T-Data-Center/3.0/installation/GUID-BA34FB2A-6780-41C5-B895-F37E5A7B7BAE.html
NEW QUESTION # 58
Which three steps must be carried out to configure North-South / East-West Network Inspection? (Choose three.)
- A. Service Registration
- B. Service Introspection
- C. Service Consumption
- D. Service Deployment
- E. Service Insertion
Answer: A,C,D
Explanation:
Use these steps to configure north-south and east-west Network Introspection:
1. Service Registration: Service registration makes a service available in the catalog.
2. Service Deployment: Deploy an instance of a registered service.
3. Service Consumption: Use services in a service chain and redirect traffic.
Taken from NSX-T ICM 3.0 Lecture Manual.
NEW QUESTION # 59
......
The 2V0-41.20 certification exam is intended for IT professionals who work with VMware NSX-T Data Center on a daily basis, including network and security administrators, architects, and engineers. 2V0-41.20 exam consists of 70 multiple-choice questions and has a time limit of 130 minutes. The passing score for 2V0-41.20 exam is 300 out of 500 points. Candidates who pass the exam demonstrate a strong command of NSX-T Data Center concepts and the ability to apply them to real-world scenarios.
VMware 2V0-41.20 exam consists of multiple-choice questions and requires a thorough understanding of VMware NSX-T Data Center concepts. Candidates who pass 2V0-41.20 exam will be able to demonstrate their ability to design, install, configure, and manage NSX-T Data Center solutions.
Pass VMware 2V0-41.20 Premium Files Test Engine pdf - Free Dumps Collection: https://www.passcollection.com/2V0-41.20_real-exams.html
2V0-41.20 Exam Info and Free Practice Test | PassCollection: https://drive.google.com/open?id=1ySP34eaJiC2QR5IeDAywJ-Gc0tw82EOz
